|Date||Date of Registration : Oct 12, 2005
Date of Revision : Apr 09, 2018
|Country / Area||Tokyo, Japan|
2619 Other processing machines and parts of such
2203 Hand tools, tools, blades (excluding weapons)
|Target Country / Area||All Countries / Areas|
*Attention: JETRO shall not take any responsibility for the contents provided by users. Please take note of the fact that JETRO leaves the exactness and reliability of the contents to users' judgment.
slot die for thin film coating
<< FEATURES & CHARACTERISTICS >>
Super-accurate coating technology anticipates a next generation's needs!
1.The Characteristics of Die Coating
1)A coating liquid can be coated on the film directly.
2)The coating speed is faster than that of Roll Coating.
3)The coating thickness can be maintained accurately in both the width and length directions resulting in a very smooth film surface.
4)Since back up rolls are not used and the coating liquid is applied directly to the film, problems such a splattering are solved and higher coating speed can be attained.
2.Our Die Coater characteristics
---> Cemented Carbide Die Coter
The Characteristics of Cemented Carbide Slot Die are;
1)The edge parts are made of ultra micro grain cemented carbide.
2)The use of cemented carbide improves the accuracy of the degree of the straightness of the edge.
3)The Slot Die maintains a sharp edge because of incorporation which have a diameter of no more than 1MIC. ( Edge parts do not occur a burr.)
4)Due to the excellent processing technology, many different edge shapes including curves of high precision can be produced.
5)Edge processed lapping enables a stable coating surface that reduces the uneveness of the application.
---> Slit-Width Adjustment Mechanism
1)Adjustable slit width by micron order
2)Quantitative control by digital display
1)The degree of straightness on a slot side
--->0.002mm or below (overall length 1,100mm)
0.001mm or below (overall length 600mm)
With regard to an accuracy, we can determine the degree of accuracy upon consulting with you.
2)The degree of finished surface roughness at the edge
A. R side edge ---> Ry (Rmax) 0.2S
B. Flat side edge--->Ry (Rmax) 0.1S
3)The swell of top side at the edge
|Conditions of Products
/ Parts Inventory
|Orders from Individual|
|Trade Terms||COST INSURANCE AND FREIGHT (CIF)|
Tokyo, JapanApr 28, 2010 RegistrationApr 11, 2018 Revision
Total Sum of CONTACT Received : 5
Tokyo, JapanOct 06, 2005 RegistrationApr 11, 2018 Revision
Total Sum of CONTACT Received : 2
Tokyo, JapanOct 07, 2005 RegistrationApr 09, 2018 Revision
Total Sum of CONTACT Received : 1